R2(conf-if-te-1/1-vrid-10)#virtual-address fe80::10R2(conf-if-te-1/1-vrid-10)#virtual-address 1::10R2(conf-if-te-1/1-vrid-10)#no shutdownR2(conf-if-te-1/1)#show configinterface TenGigabitEthernet 1/1ipv6 address 1::1/64vrrp-group 10priority 100virtual-address fe80::10virtual-address 1::10no shutdownR2(conf-if-te-1/1)#endR2#show vrrp------------------TenGigabitEthernet 1/1, IPv6 VRID: 10, Version: 3, Net:fe80::201:e8ff:fe6a:c59fVRF: 0 default-vrfState: Master, Priority: 100, Master: fe80::201:e8ff:fe6a:c59f (local)Hold Down: 0 centisec, Preempt: TRUE, AdvInt: 100 centisecAccept Mode: FALSE, Master AdvInt: 100 centisecAdv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 135Virtual MAC address:00:00:5e:00:02:0aVirtual IP address:1::10 fe80::10Router 3R3(conf)#interface tengigabitethernet 1/2R3(conf-if-te-1/2)#no ipv6 addressR3(conf-if-te-1/2)#ipv6 address 1::2/64R3(conf-if-te-1/2)#vrrp-group 10R2(conf-if-te-1/2-vrid-10)#virtual-address fe80::10R2(conf-if-te-1/2-vrid-10)#virtual-address 1::10R3(conf-if-te-1/2-vrid-10)#no shutdownR3(conf-if-te-1/2)#show configinterface TenGigabitEthernet 1/2ipv6 address 1::2/64vrrp-group 10priority 100virtual-address fe80::10virtual-address 1::10no shutdownR3(conf-if-te-1/2)#endR3#show vrrp------------------TenGigabitEthernet 1/2, IPv6 VRID: 10, Version: 3, Net:fe80::201:e8ff:fe6b:1845VRF: 0 default-vrfState: Backup, Priority: 100, Master: fe80::201:e8ff:fe6a:c59fHold Down: 0 centisec, Preempt: TRUE, AdvInt: 100 centisecAccept Mode: FALSE, Master AdvInt: 100 centisecAdv rcvd: 11, Bad pkts rcvd: 0, Adv sent: 0Virtual MAC address:00:00:5e:00:02:0aVRRP in a VRF ConfigurationThe following example shows how to enable VRRP operation in a VRF virtualized network for the following scenarios.• Multiple VRFs on physical interfaces running VRRP.• Multiple VRFs on VLAN interfaces running VRRP.To view a VRRP in a VRF configuration, use the show commands.Virtual Router Redundancy Protocol (VRRP) 993