interface TenGigabitEthernet 1/2no ip addressswitchportno shutdownDell(conf-if)#ip address 10.10.1.1 /24% Error: Port is in Layer 2 mode Te 1/2.Dell(conf-if)#To determine the configuration of an interface, use the show config command in INTERFACE mode or the various showinterface commands in EXEC mode.Configuring Layer 3 (Interface) ModeTo assign an IP address, use the following commands.• Enable the interface.INTERFACE modeno shutdown• Configure a primary IP address and mask on the interface.INTERFACE modeip address ip-address mask [secondary]The ip-address must be in dotted-decimal format (A.B.C.D) and the mask must be in slash format (/xx).Add the keyword secondary if the IP address is the interface’s backup IP address.Example of the show ip interface CommandYou can only configure one primary IP address per interface. You can configure up to 255 secondary IP addresses on a singleinterface.To view all interfaces to see with an IP address assigned, use the show ip interfaces brief command in EXEC mode asshown in View Basic Interface Information.To view IP information on an interface in Layer 3 mode, use the show ip interface command in EXEC Privilege mode.Dell>show ip int vlan 58Vlan 58 is up, line protocol is upInternet address is 1.1.49.1/24Broadcast address is 1.1.49.255Address determined by config fileMTU is 1554 bytesInbound access list is not setProxy ARP is enabledSplit Horizon is enabledPoison Reverse is disabledICMP redirects are not sentICMP unreachables are not sentEgress Interface Selection (EIS)EIS allows you to isolate the management and front-end port domains by preventing switch-initiated traffic routing between the twodomains. This feature provides additional security by preventing flooding attacks on front-end ports. The following protocols supportEIS: DNS, FTP, NTP, RADIUS, sFlow, SNMP, SSH, Syslog, TACACS, Telnet, and TFTP. This feature does not support sFlow onstacked units.When you enable this feature, all management routes (connected, static, and default) are copied to the management EIS routingtable. Use the management route command to add new management routes to the default and EIS routing tables. Use the showip management-eis-route command to view the EIS routes.372 Interfaces