-- stack-unit 0 --Current Settings(in block sizes) Next Boot(in block sizes)1 block = 256 entriesL2Acl : 2 1Ipv4Acl : 2 8(UdfEnabled)Ipv6Acl : 0 2Ipv4Qos : 2 0L2Qos : 1 2L2PT : 0 0IpMacAcl : 0 0VmanQos : 0 0EcfmAcl : 2 0FcoeAcl : 4 0iscsiOptAcl : 0 0ipv4pbr : 0 0vrfv4Acl : 0 0Openflow : 0 0fedgovacl : 0 0nlbclusteracl: 0 0Dell#4. Create a UDF packet format in the UDF TCAM table.CONFIGURATION modeudf-tcam name seq numberDell(conf)#udf-tcam ipnip seq 15. Configure a UDF ID to parse packet headers using the specified number of offset and required bytes.CONFIGURATION-UDF TCAM modekey description udf-id id packetbase PacketBase offset bytes length bytesDell(conf-udf-tcam)#key innerL3header udf-id 6 packetbase innerL3Header offset 0 length26. View the UDF TCAM configuration.CONFIGURATION-UDF TCAM modeshow configDell(conf-udf-tcam)#show config!udf-tcam ipnip seq 1key innerL3header udf-id 6 packetbase innerL3Header offset 0 length 2Dell(conf-udf-tcam)#7. Configure the match criteria for the packet type in which UDF offset bytes are parsed.CONFIGURATION-UDF TCAM modematch l2ethertype ipv4 ipprotocol value vlantag tagStatusDell(conf-udf-tcam)#match l2ethertype ipv4 ipprotocol 4 vlantag any8. View the UDF TCAM configuration.CONFIGURATION-UDF TCAM modeshow configDell(conf-udf-tcam)#show config!udf-tcam ipnip seq 1match l2ethertype ipv4 ipprotocol 4 vlantag anyDell(conf-udf-tcam)#9. Create a UDF qualifier to assign values to UDF IDs.140 Access Control Lists (ACLs)
