Queueing strategy: fifo0 packets input, 0 bytesInput 0 IP Packets, 0 Vlans 0 MPLS0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pktsReceived 0 input symbol errors, 0 runts, 0 giants, 0 throttles0 CRC, 0 IP Checksum, 0 overrun, 0 discarded0 packets output, 0 bytes, 0 underrunsOutput 0 Multicasts, 0 Broadcasts, 0 Unicasts0 IP Packets, 0 Vlans, 0 MPLS0 throttles, 0 discardedRate info (interval 100 seconds):Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rateOutput 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rateTime since last interface status change: 1d23h42mDynamic CountersBy default, counting is enabled for IPFLOW, IPACL, L2ACL, L2FIB.For the remaining applications, Dell Networking OS automatically turns on counting when you enable the application, and is turnedoff when you disable the application.NOTE: If you enable more than four counter-dependent applications on a port pipe, there is an impact on line rateperformance.The following counter-dependent applications are supported by Dell Networking OS:• Egress VLAN• Ingress VLAN• Next Hop 2• Next Hop 1• Egress ACLs• ILM• IP FLOW• IP ACL• IP FIB• L2 ACL• L2 FIBClearing Interface CountersThe counters in the show interfaces command are reset by the clear counters command. This command does not clearthe counters any SNMP program captures.To clear the counters, use the following the command.• Clear the counters used in the show interface commands for all VRRP groups, VLANs, and physical interfaces or selectedones. Without an interface specified, the command clears all interface counters.EXEC Privilege modeclear counters [interface] [vrrp [vrid] | learning-limit](OPTIONAL) Enter the following interface keywords and slot/port or number information:– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/subport] information.– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.– For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/portinformation. The slot range is from 1 to 6. The port range is 1.Interfaces 399