Disabling and Undoing LLDP on Management PortsTo disable or undo LLDP on management ports, use the following command.1. Enter Protocol LLDP mode.CONFIGURATION mode.protocol lldp2. Enter LLDP management-interface mode.LLDP-MANAGEMENT-INTERFACE mode.management-interface3. Enter the disable command.LLDP-MANAGEMENT-INTERFACE mode.To undo an LLDP management port configuration, precede the relevant command with the keyword no.Advertising TLVsYou can configure the system to advertise TLVs out of all interfaces or out of specific interfaces.• If you configure the system globally, all interfaces send LLDPDUs with the specified TLVs.• If you configure an interface, only the interface sends LLDPDUs with the specified TLVs.• If you configure LLDP both globally and at interface level, the interface level configuration overrides the global configuration.To advertise TLVs, use the following commands.1. Enter LLDP mode.CONFIGURATION or INTERFACE modeprotocol lldp2. Advertise one or more TLVs.PROTOCOL LLDP modeadvertise {dcbx-appln-tlv | dcbx-tlv | dot3-tlv | interface-port-desc | management-tlv |med }Include the keyword for each TLV you want to advertise.• For management TLVs: system-capabilities, system-description.• For 802.1 TLVs: port-protocol-vlan-id, port-vlan-id vlan-name.• For 802.3 TLVs: max-frame-size.• For TIA-1057 TLVs:– guest-voice– guest-voice-signaling– location-identification– power-via-mdi– softphone-voice– streaming-video– video-conferencing– video-signalingLink Layer Discovery Protocol (LLDP) 505