When you configure both CLIs, the later timer rules VRRP enabling. For example, if you set vrrp delay reload 600 and vrrpdelay minimum 300, the following behavior occurs:• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and configuredfor VRRP.• When an interface comes up and becomes operational, the system waits 300 seconds (5 minutes) to bring up VRRP on thatinterface.To set the delay time for VRRP initialization, use the following commands.• Set the delay time for VRRP initialization on an individual interface.INTERFACE modevrrp delay minimum secondsThis time is the gap between an interface coming up and being operational, and VRRP enabling.The seconds range is from 0 to 900.The default is 0.• Set the delay time for VRRP initialization on all the interfaces in the system configured for VRRP.INTERFACE modevrrp delay reload secondsThis time is the gap between system boot up completion and VRRP enabling.The seconds range is from 0 to 900.The default is 0.Sample ConfigurationsBefore you set up VRRP, review the following sample configurations.VRRP for an IPv4 ConfigurationThe following configuration shows how to enable IPv4 VRRP. This example does not contain comprehensive directions and isintended to provide guidance for only a typical VRRP configuration. You can copy and paste from the example to your CLI. Tosupport your own IP addresses, interfaces, names, and so on, be sure that you make the necessary changes. The VRRP topologywas created using the CLI configuration shown in the following example.Virtual Router Redundancy Protocol (VRRP) 989