4. Enter ROUTER BGP mode.CONFIGURATION moderouter bgp as-number5. Apply the route map to the neighbor or peer group’s incoming or outgoing routes.CONFIG-ROUTER-BGP modeneighbor {ip-address | peer-group-name} route-map map-name {in | out}To view the BGP configuration, use the show config command in CONFIGURATION ROUTER BGP mode. To view a route mapconfiguration, use the show route-map command in EXEC Privilege mode.Changing the NEXT_HOP AttributeYou can change how the NEXT_HOP attribute is used.To change how the NEXT_HOP attribute is used, enter the first command. To view the BGP configuration, use the show configcommand in CONFIGURATION ROUTER BGP mode or the show running-config bgp command in EXEC Privilege mode.You can also use route maps to change this and other BGP attributes. For example, you can include the second command in a routemap to specify the next hop address.• Disable next hop processing and configure the router as the next hop for a BGP neighbor.CONFIG-ROUTER-BGP modeneighbor {ip-address | peer-group-name} next-hop-self• Sets the next hop address.CONFIG-ROUTE-MAP modeset next-hop ip-addressChanging the WEIGHT AttributeTo change how the WEIGHT attribute is used, enter the first command. You can also use route maps to change this and other BGPattributes. For example, you can include the second command in a route map to specify the next hop address.• Assign a weight to the neighbor connection.CONFIG-ROUTER-BGP modeneighbor {ip-address | peer-group-name} weight weight– weight: the range is from 0 to 65535.The default is 0.• Sets weight for the route.CONFIG-ROUTE-MAP modeset weight weight– weight: the range is from 0 to 65535.To view BGP configuration, use the show config command in CONFIGURATION ROUTER BGP mode or the show running-config bgp command in EXEC Privilege mode.Enabling MultipathBy default, the software allows one path to a destination. You can enable multipath to allow up to 64 parallel paths to a destination.NOTE: Dell Networking recommendsnot using multipath and add path simultaneously in a route reflector.To allow more than one path, use the following command.206 Border Gateway Protocol IPv4 (BGPv4)
