VLT Sample ConfigurationTo review a sample VLT configuration setup, study these steps.1. Configure the VLT domain with the same ID in VLT peer 1 and VLT peer 2.VLT DOMAIN modevlt domain domain id2. Configure the VLTi between VLT peer 1 and VLT peer 2.3. You can configure LACP/static LAG between the peer units (not shown).CONFIGURATION modeinterface port-channel port-channel idNOTE: To benefit from the protocol negotiations, Dell Networking recommends configuring VLTs used as facinghosts/switches with LACP. Ensure both peers use the same port channel ID.4. Configure the peer-link port-channel in the VLT domains of each peer unit.INTERFACE PORTCHANNEL modechannel-member5. Configure the backup link between the VLT peer units (shown in the following example).6. Configure the peer 2 management ip/ interface ip for which connectivity is present in VLT peer 1.EXEC Privilege modeshow running-config vlt7. Configure the peer 1 management ip/ interface ip for which connectivity is present in VLT peer 1.EXEC mode or EXEC Privilege modeshow interfaces interface8. Configure the VLT links between VLT peer 1 and VLT peer 2 to the top of rack unit (shown in the following example).9. Configure the static LAG/LACP between ports connected from VLT peer 1 and VLT peer 2 to the top of rack unit.EXEC Privilege modeshow running-config entity10. Configure the VLT peer link port channel id in VLT peer 1 and VLT peer 2.EXEC mode or EXEC Privilege modeshow interfaces interface11. In the top of rack unit, configure LACP in the physical ports.EXEC Privilege modeshow running-config entity12. Verify that VLT is running.EXEC modeshow vlt brief or show vlt detail13. Verify that the VLT LAG is running in both VLT peer units.EXEC mode or EXEC Privilege modeshow interfaces interfaceExample of Configuring VLTIn the following sample VLT configuration steps, VLT peer 1 is Dell-2, VLT peer 2 is Dell-4, and the ToR is S60-1.920 Virtual Link Trunking (VLT)
