redistribute {bgp as-number | connected | rip | static} [level-1 level-1-2 | level-2][metric metric-value] [metric-type {external | internal}] [route-map map-name]Configure the following parameters:– level-1, level-1-2, or level-2: assign all redistributed routes to a level. The default is level-2.– metric-value: the range is from 0 to 16777215. The default is 0.– metric-type: choose either external or internal. The default is internal.– map-name: enter the name of a configured route map.• Include specific OSPF routes in IS-IS.ROUTER ISIS moderedistribute ospf process-id [level-1| level-1-2 | level-2] [metric value] [matchexternal {1 | 2} | match internal] [metric-type {external | internal}] [route-map map-name]Configure the following parameters:– process-id: the range is from 1 to 65535.– level-1, level-1-2, or level-2: assign all redistributed routes to a level. The default is level-2.– metric value: the range is from 0 to 16777215. The default is 0.– metric value: the range is from 0 to 16777215. The default is 0.– match external: the range is 1 or 2.– match internal– metric-type: external or internal.– map-name: name of a configured route map.To view the IS-IS configuration globally (including both IPv4 and IPv6 settings), use the show running-config isis commandin EXEC Privilege mode. To view the current IPv4 IS-IS configuration, use the show config command in ROUTER ISIS mode. Toview the current IPv6 IS-IS configuration, use the show config command in ROUTER ISIS-ADDRESS FAMILY IPV6 mode.Configuring Authentication PasswordsYou can assign an authentication password for routers in Level 1 and for routers in Level 2.Because Level 1 and Level 2 routers do not communicate with each other, you can assign different passwords for Level 1 routers andfor Level 2 routers. However, if you want the routers in the level to communicate with each other, configure them with the samepassword.To configure a simple text password, use the following commands.• Configure authentication password for an area.ROUTER ISIS modearea-password [hmac-md5] passwordFTOS supports HMAC-MD5 authentication.This password is inserted in Level 1 LSPs, Complete SNPs, and Partial SNPs.• Set the authentication password for a routing domain.ROUTER ISIS modedomain-password [encryption-type | hmac-md5] passwordFTOS supports both DES and HMAC-MD5 authentication methods.This password is inserted in Level 2 LSPs, Complete SNPs, and Partial SNPs.To view the passwords, use the show config command in ROUTER ISIS mode or the show running-config isiscommand in EXEC Privilege mode.Intermediate System to Intermediate System 461