[no] fcoe priority-bits priority-bitmapThe priority-bitmap range is from 1 to FF.The default is 0x8.7. Configure the iSCSI priority advertised for the iSCSI protocol in Application Priority TLVs.PROTOCOL LLDP mode[no] iscsi priority-bits priority-bitmapThe priority-bitmap range is from 1 to FF.The default is 0x10.DCBx Error MessagesThe following syslog messages appear when an error in DCBx operation occurs.LLDP_MULTIPLE_PEER_DETECTED: DCBx is operationally disabled after detecting more than oneDCBxpeer on the port interface.LLDP_PEER_AGE_OUT: DCBx is disabled as a result of LLDP timing out on a DCBx peer interface.DSM_DCBx_PEER_VERSION_CONFLICT: A local port expected to receive the IEEE, CIN, or CEEversionin a DCBx TLV from a remote peer but received a different, conflicting DCBx version.DSM_DCBx_PFC_PARAMETERS_MATCH and DSM_DCBx_PFC_PARAMETERS_MISMATCH: A local DCBx portreceiveda compatible (match) or incompatible (mismatch) PFC configuration from a peer.DSM_DCBx_ETS_PARAMETERS_MATCH and DSM_DCBx_ETS_PARAMETERS_MISMATCH: A local DCBx portreceiveda compatible (match) or incompatible (mismatch) ETS configuration from a peer.LLDP_UNRECOGNISED_DCBx_TLV_RECEIVED: A local DCBx port received an unrecognized DCBx TLVfroma peer.Debugging DCBx on an InterfaceTo enable DCBx debug traces for all or a specific control paths, use the following command.• Enable DCBx debugging.EXEC PRIVILEGE modedebug DCBx {all | auto-detect-timer | config-exchng | fail | mgmt | resource | sem | tlv}– all: enables all DCBx debugging operations.– auto-detect-timer: enables traces for DCBx auto-detect timers.– config-exchng: enables traces for DCBx configuration exchanges.– fail: enables traces for DCBx failures.– mgmt: enables traces for DCBx management frames.– resource: enables traces for DCBx system resource frames.– sem: enables traces for the DCBx state machine.– tlv: enables traces for DCBx TLVs.266 Data Center Bridging (DCB)
