Denon AVR-4810 Owner's Manual

Also see for AVR-4810: Service manual

Contents

Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsSettingsENGLISHMaking Detailed Settings (Manual Setup)Main remote control unitoperation buttons:Displaying the menuCancel the menu:Moves the cursor(Up/Down/Left/Right) :Confirm the setting :Return to previous menuSetting items Setting contentsNetwork Connecting(Continued)If the access points are repeat search, use i to select the “Search”and press ENTER.NETWORK CONNECTINGSearchSelect access point to connectPlease select access point to connect.WEPDENONRETURN CancelEnter82%e If there is an encryption setting for the access point you selected instep w, enter same encryption key as used for the access point. (Ifthere is no encryption setting, proceed to step t.)NETWORK CONNECTINGConnectionEnter encryption keyEnter same encryption key (security) key as usedWEP Key1Default KeyRETURN CancelEnterfor access pointAAAAAUse uio p to input the “Key” (encryption key) and press ENTER.Enter the same encryption key as used for the access point.The types of characters that can be input are as shown below.GLower case charactersH abcdefghijklmnopqrstuvwxyzGUpper case charactersH ABCDEFGHIJKLMNOPQRSTUVWXYZGSymbolsH ! “ # $ % & ’ ( ) * + , - . / : ; < = > ? @ [ \ ] ˆ _ ` { | } ˜GNumbersH 0123456789 (Space)You can change the character type when you press SEARCH on themain remote control unit or MENU during character input.When no security settings have been used in the Internet connectionsettings, this step is not necessary.r When encryption is by “WEP”, select the “Default Key” using i, andthen press o p.1 / 2 / 3 / 4 : Select the same default key as used for the access point.This should normally be set to “1”.b••Make network settings.Making the Network Settings (Network Setup)Default settings are underlined.Setting items Setting contentsNetwork ConnectingMake settings for wired orwireless LAN.Wireless LAN settingsUse this procedure to configure the Wireless LAN settings.1. Fitting a rod antenna (vpage 25 “Connecting to a Home Network(LAN)”).If a LAN cable is connected, remove it.2. Turn on the AVR-4810 (vpage 27 “Turning the Power On”).3. Set the access point at the “Network Connecting”.When searching access points to connect automatically, refer to“Automatic settings”.When searching access points to connect manually, refer to “Manualsettings”.bAutomatic settingsNETWORK CONNECTINGManualSearchSearch and set the access pointwireless LAN hostEnterSelect a connection method appropriate for yourWPSRETURN CancelNETWORK CONNECTINGSearchSelect access point to connectPlease select access point to connect.WEPDENONRETURN CancelEnter82%q On the GUI menu, select “Network Connecting” – “Search” and pressENTER.The access point you have set is displayed.w Use ui to select the access point, and then press ENTER.The DHCP function is disabled.nqwerSelecttSee overleaf