Denon AVR-4810 Owner's Manual

Also see for AVR-4810: Service manual

Contents

0Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsSettingsENGLISHMaking Detailed Settings (Manual Setup)Main remote control unitoperation buttons:Displaying the menuCancel the menu:Moves the cursor(Up/Down/Left/Right) :Confirm the setting :Return to previous menuSetting items Setting contentsOther(Continued)Party Start Level : Make settings for volume level when the Party Modeis started.Last : The same volume as set before the party mode was started.– – – (0) : Always use the muting on condition when the Party Mode isstarted.–80dB ~ 18dB (1 ~ 99) : Start party mode with your preferred volume.This can be set when “Party Mode Function“ is set to “ON“.This is displayed from 0 to 99 when “Volume Display” (vpage 52) isset to “Absolute”.You can set to the upper limit set with “Volume Limit” (vpage 52) .••••••Network Status : Displays up to a maximum of 10 DENON productsconnected on the same network.Friendly Name / Model Name / Power ON/Standby / Select Source /Volume Level / Party Mode status“Network Status” is only displayed for DENON products supportingthe Network Status function.•Update Notification : Displays a notification message on the AVR-4810’sGUI screen when the latest firmware is released with “Firmware Update”.The notification message is displayed for about 20 seconds when thepower is turned on. Connect to broadband Internet (vpage 25) whenusing this function.ON : Display update message.OFF : Do not display update message.When you press ENTER during display of the notification message, the“Check for Update” screen is displayed. (Refer to page 55 for moreinformation on “Firmware Update”.)Press RETURN to erase the notification message.••••Upgrade Notification : Display a notification message on the AVR-4810’sGUI screen when downloadable firmware is released with “Add NewFeature”. The notification message is displayed for about 20 secondswhen the power is turned on. Connect to broadband Internet (vpage25) when using this function.ON : Display upgrade message.OFF : Do not display upgrade message.When you press ENTER during display of the notification message, the“Add New Feature” screen is displayed. (Refer to page 55 for moreinformation on “Add New Feature”.)Press RETURN to erase the notification message.••••Setting items Setting contentsNapster AccountSet or change Usernameand Password (vpage 75“Listening to Napster“).Username / PasswordThe types of characters that can be input are as shown below.GLower case charactersH abcdefghijklmnopqrstuvwxyzGUpper case charactersH ABCDEFGHIJKLMNOPQRSTUVWXYZGSymbolsH ! “ # $ % & ’ ( ) * + , - . / : ; < = > ? @ [ \ ] ˆ _ ` { | } ˜GNumbersH 0123456789 (Space)You can change the character type when you press SEARCH on the mainremote control unit or MENU during character input.The password may not contain underscores ( _ ).••Network InformationDisplay network information.Friendly Name / Network=Wired/Wireless / SSID /DHCP= ON/OFF / IP Address / MAC Address