Eaton Powerware Series User Manual

Also see for Powerware Series: Installation and operation manual User guide User guide User guide Installation and operation manual

Contents

INSTALLATIONEATON BladeUPS® (12 kVA) User's Guide 164201649 Rev 4www.eaton.com/powerquality5818. If your rack has conductors for grounding or bonding of ungrounded metal parts,connect the ground cable (not included) to the ground bonding screw. SeeFigure 32 on page 43 for the location of the ground bonding screw.19. You can install an optional REPO circuit that will shut down the entire parallelsystem using a single switch. See “Remote Emergency Power-off” on page 83to install the REPO switch before powering on the parallel system.20. Connect the parallel input cord from each paralleled UPS to the BladeUPS Bar inthe rack as shown in Figure 43.Gently loop and twist the parallel input cords as shown to minimize stress on thecords. The loop and twist for each cord may vary depending on configuration andstrain relief.21. Continue to “Parallel System Initial Startup” on page 60. If you installed theadditional UPS(s) without shutting down the parallel system, perform the steps in“Parallel System Initial Startup”on the additional UPS(s) only.Figure 43. Connecting UPSs to the BladeUPS Bar (Bottom Entry Shown)