Configuration andparameterization witheasySoft-CoDeSys9703/11 MN05013002Z-ENParameters for the SmartWire-DT networkTable 10: Parameters for the SmartWire-DT networkParameters Value MeaningBaud rate SmartWire-DT(0 - 7)4 The baud rate of the SmartWire-DT network.Setting options:• 4 = 125 kBit/s (Default)• 5 = 250 kBit/s (from operating system V1.10)Compatible devicesallowed(1 = Yes,0 = No)0 The planned slaves in the CANopen configuration mustcomply with the slaves of the stored gateway target configu-ration. If not, no data interchange takes place with the CANmaster.1 Data interchange also takes place, if the SmartWire-DT slavesare not identical to the CANopen configuration, but arecompatible with each other. This is indicated by the Status LEDon the device.(You will find the list of devices that are compatible with oneanother in Table 15, page 125.)All slaves optional(1 = Yes,0 = No)0 A data transfer to the CANopen master takes place only if allSmartWire-DT slaves for which the parameter "Device pres-ence" = 1 (obligatory slave) is set are actually present in thenetwork. Specification is performed individually for each slave.1 A data transfer to CANopen also takes place, if there are arandom number of failed SmartWire-DT slaves. The setting inthe module parameters has no effect.