Configuration andparameterization witheasySoft-CoDeSys9303/11 MN05013002Z-ENSelecting the SmartWire-DT slaveX Change over to the CAN module selection tab.X Now select here the SmartWire-DT slaves that you requirefor your SmartWire-DT network. Please heed of the correctsequence. The modules must be configured just as theywill be arranged afterwards in your application.Figure 38: Selection of the slavesFor downloading the configuration please select the boxCreate SDOs for module list. In this way the targetconfiguration stored in the gateway can be compared withthe one drawn up here in the programming system. If thisbox is not selected, you must set the parameter "Disableconfiguration check" in the Service data objects tab toTrue (= 1).
