Programming theEU5C-SWD-DP5403/11 MN05013002Z-ENParameter assignment tabIn this tab set the general settings of the SmartWire-DTgateway and the SmartWire-DT network under Stationparameters -> Device-specific parameters.The figure shows the factory set parameters. The followingtable shows the parameters, their meaning and possiblesettings.Table 6: ApplicationParameterParameters Value MeaningBaud rate SmartWire-DT 125 kBit/s (Default)250 kBit/s (from oper-ating system version1.10)The baud rate of the SmartWire-DT networkCompatible devicesallowed(Compatible devicespermissible.)No The planned SmartWire-DT slaves in theconfiguration must comply with the slaves ofthe stored gateway target configuration. Ifnot, no data interchange takes place with theDP master.YES Data exchange takes place if the connectedSmartWire-DT slaves are compatible with theSmartWire-DT slaves in the STEP7 DP configu-ration. This is indicated by the Status LED onthe device.All slaves optional(All devices areoptional.)Defined for each slave(Define for each device)Specification is performed individually foreach slave (a section “Parameters of indi-vidual SmartWire-DT slaves”)YES Data transmission to the PROFIBUS also takesplace for a random number of failed Smart-Wire-DT slaves.The individual setting in the module parame-ters has no effect.
