Programming theEU5C-SWD-DP3003/11 MN05013002Z-ENConfiguration andparameterization witheasySoft-CoDeSysThe connection of a SmartWire-DT network via the gatewayEU5C-SWD-DP to the controller XC200 is described in thissection. Please check beforehand whether you have acurrent easySoft-CoDeSys version installed with the neces-sary GSD files.Then please proceed as follows:X Start easySoft-CoDeSys and open a project.X Open the controller configuration and select thePROFIBUS gateway adapter XIOC-NET DP M. This must bepositioned on the first three slots.Figure 9: Selection of the DP master