12. Rotate the drive cage back into the server until it stops; then, press and holdthe retaining tab on top of the drive cage while you rotate the drive cage intothe chassis until it locks into place.13. Reinstall the hard disk drives.Note: Before you continue, check all internal power cables to make sure thatthey are connected to the system board and other optional devices.14. Install the side cover (see “Installing the side cover” on page 53).15. Lock the side cover.16. Reconnect the external cables and power cords; then, turn on the attacheddevices and turn on the server.Removing an IBM Remote Supervisor Adapter II SlimLineTo remove a Remote Supervisor Adapter II SlimLine from the server, complete thefollowing steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 47.2. Turn off the server and all attached devices; then, disconnect all power cordsand external cables.3. Unlock and remove the side cover (see “Removing the side cover” on page 52).4. Rotate the rear adapter-retention bracket out of the server.5. Press the Remote Supervisor Adapter II SlimLine support bracket retention clipoutward slightly and grasp the Remote Supervisor Adapter II SlimLine and lift itout of the server.Remote Supervisor IISlimLine adaptersupport bracketRemote Supervisor IISlimLine adapterretainer clipRemote Supervisor IISlimLine adapter6. If you are instructed to return the adapter, follow all packaging instructions, anduse any packaging materials for shipping that are supplied to you.Installing an IBM Remote Supervisor Adapter II SlimLineAn optional IBM Remote Supervisor Adapter II SlimLine must be installed only in itsdedicated connector on the system board. See “System-board internal connectors”on page 9102 System x3200 M2 Types 4367 and 4368: Problem Determination and Service Guide
