2. When the message Press F1 for Configuration/Setup, Press F12 for BootMenu is displayed, press F1. (This prompt is displayed on the screen for only afew seconds. You must press F1 quickly.) If you have set both a power-onpassword and an administrator password, you must type the administratorpassword to access the full Configuration/Setup Utility menu. If you do not typethe administrator password, a limited Configuration/Setup Utility menu isavailable.3. Follow the instructions on the screen.Configuration/Setup Utility menu choicesThe following choices are on the Configuration/Setup Utility main menu. Dependingon the version of the BIOS code, some menu choices might differ slightly fromthese descriptions.Note: When you use the server for the first time, you might want to use theConfiguration/Setup Utility menu choice Load Default Settings to reset theConfiguration/Setup Utility menu choices to the factory default settings, in case theywere changed before you received the server. Otherwise, some choices might notbe displayed in the menu.v System SummarySelect this choice to view configuration information, including the amount ofinstalled memory. When you make configuration changes through other choicesin the Configuration/Setup Utility program, the changes are reflected in thesystem summary; you cannot change settings directly in the system summary.This choice is on the full and limited Configuration/Setup Utility menu.– Processor SummarySelect this choice to view the processor information, including the type, speed,and cache size of the microprocessor.v System InformationSelect this choice to view information about the server. When you make changesthrough other choices in the Configuration/Setup Utility program, some of thosechanges are reflected in the system information; you cannot change settingsdirectly in the system information.This choice is on the full Configuration/Setup Utility menu only.v Devices and I/O PortsSelect this choice to view or change device assignments and input/output (I/O)ports. Select this choice to enable or disable the integrated SAS/SATA controllerand Ethernet controller, and standard connectors (such as serial and parallel).Enable is the default setting for all controllers. If you disable a device, it cannotbe configured, and the operating system will not be able to detect it (this isequivalent to disconnecting the device). If you disable the integrated SAS/SATAcontroller and no SAS/SATA adapter is installed, the server will have noSAS/SATA capability. If you disable the integrated Ethernet controller and noEthernet adapter is installed, the server will have no Ethernet capability.This choice is on the full Configuration/Setup Utility menu only.– Serial Port 1Select this choice to set up serial port 1.– Serial Port 2Select this choice to set up serial port 2.– Parallel Port SetupSelect this choice to set up the parallel port and to adjust the parallel portresources and features.Chapter 2. Configuration information and instructions 17
