Tape driveEMC shieldDrive retainer clip9. If you are instructed to return the drive, follow all packaging instructions, anduse any packaging materials for shipping that are supplied to you.Installing a tape driveTo install a tape drive, complete the following steps:1. If you are replacing a removed drive with a new drive, make sure that:v You have all the cables and other equipment that is specified in thedocumentation that comes with the new drive.v You check the instructions that come with the new drive to determinewhether you must set any switches or jumpers on the drive.v You have removed the drive retainer clip on the side of the old drive andhave it available for installation on the new drive.2. Read the safety information that begins on page vii and “Installation guidelines”on page 47.3. Turn off the server and peripheral devices, and disconnect the power cordsand all external cables.4. Unlock and remove the side cover (see “Installing the side cover” on page 53).5. Remove the upper bezel (see “Installing the upper bezel” on page 57).6. Remove the lower bezel (see “Installing the lower bezel” on page 55).7. Touch the static-protective package that contains the drive to any unpaintedmetal surface on the server; then, remove the drive from the package andplace it on a static-protective surface.8. Set any jumpers or switches on the drive according to the documentation thatcomes with the drive.9. Remove the drive retainer clip from the side of the drive cage of bays 1 or 2.Slide the drive retainer clip to the right to remove it from the drive cage; then,snap the drive retainer clip into the screw holes on the side of the drive.66 System x3200 M2 Types 4367 and 4368: Problem Determination and Service Guide
