data, and to remotely manage a network. For information about using theseprograms, see “Using the mini-baseboard management controller utilityprograms” on page 23.v Boot Menu programThe Boot Menu program is part of the BIOS code. Use it to override the startupsequence that is set in the Configuration/Setup Utility program and temporarilyassign a device to be first in the startup sequence. For information about usingthis program, see “Using the Boot Menu program” on page 26.v Broadcom NetXtreme Gigabit Ethernet Boot AgentThe Broadcom NetXtreme Gigabit Ethernet Boot Agent is part of the BIOS. Youcan use it to configure the network as a startable device, and you can customizewhere the network startup optional devices occur in the startup sequence. Enableand disable the Broadcom NetXtreme Gigabit Ethernet Boot Agent from theConfiguration/Setup Utility program. For information, see “Enabling the BroadcomNetXtreme Gigabit Ethernet Boot Agent” on page 26.v Broadcom NetXtreme Gigabit Ethernet controller configurationTo configure the integrated Gigabit Ethernet controller, see “Configuring theBroadcom NetXtreme Gigabit Ethernet controller” on page 27.v LSI Configuration Utility programUse the LSI Configuration Utility program to configure the integrated SAS/SATAcontroller with RAID capabilities and the devices that are attached to it. Forinformation about using this program, see “LSI Configuration Utility program” onpage 27.The following table lists the different server configurations and the applicationsthat are available for configuring and managing RAID arrays.Table 3.Server configurationRAID array configuration(before operating system isinstalled)RAID array management(after operating system isinstalled)Integrated SATA and no SAScontroller card installedNone NoneSAS/SATA controller card(LSI 1064e) installedLSI Utility (BIOS UtilityCtrl+C), ServerGuideMyStorage (for monitoringstorage only)ServeRAID-MR10i adapterinstalledServeRAID ManagerHardware Boot CD, BIOSUtility (Ctrl+A), ServerGuideServeRAID Manager,ARCCONF (CLI)v Remote Supervisor Adapter II SlimLine configurationFor information about setting up and cabling a Remote Supervisor Adapter IISlimLine for use in an Advanced System Management (ASM) network, see“Setting up a Remote Supervisor Adapter II SlimLine” on page 29.Using the Configuration/Setup Utility programThis section provides instructions for starting the Configuration/Setup Utility programand descriptions of the menu choices that are available.Starting the Configuration/Setup Utility programTo start the Configuration/Setup Utility program, complete the following steps:1. Turn on the server. If the server is already on when you start this procedure,you must shut down the operating system, turn off the server, wait a fewseconds until all in-use LEDs are turned off, and restart the server.16 System x3200 M2 Types 4367 and 4368: Problem Determination and Service Guide
