- BMC Serial Port Access ModeSelect this choice to set the mini-BMC access mode for the system serialport. Shared is the default setting. You can choose from the followingaccess modes:SharedThe serial port is available for use by POST and the operatingsystem, however, the mni-BMC can still monitor the serial data fora take-control sequence.Pre-BootThe mini-BMC has control of the serial port before the operatingsystem is booted, however, after the operating system is booted,the mini-BMC will not have access to the serial port until you turnoff the server or reset the settings.DedicatedThe mini-BMC has complete control of the serial port. POST andthe operating system will not be allowed to use the serial port.DisabledThe mini-BMC has access to the serial port.- Reboot System on NMIThis option sets the mini-BMC timer to automatically reboot the server afteran NMI occurs. Enabled is the default setting.- User Account SettingsSelect this choice to view the user account settings for the mini-BMC.- BMC Network ConfigurationSelect this choice to configure specific network settings for the mini-BMC.- BMC System Event LogSelect this choice to view the mini-BMC system-event log, which containsall system-error messages that have been generated. Use the arrow keysto move among pages in the log. Run the diagnostic programs to get moreinformation about the error codes. Select Clear BMC System Event Log toclear the mini-BMC system-event logs.v Event/Error LogsSelect this choice to view or clear error logs.– System Event/Error LogSelect this choice to view the system-event and error messages that thesystem generated during POST and run time. by the SMI handler and by theservice processor. The most recent event or error is displayed first. Use theDown Arrow key to view the older entries, and use the Up Arrow key to viewthe newer entries. Select Clear system logs and press Enter to erase thesystem event/error log.v Save SettingsSelect this choice to save the changes that you have made in the settings.v Restore SettingsSelect this choice to cancel the changes that you have made in the settings andrestore the previous settings.v Load Default SettingsSelect this choice to cancel the changes that you have made in the settings andrestore the factory settings.v Exit Setup20 System x3200 M2 Types 4367 and 4368: Problem Determination and Service Guide
