789 SCAN OPERATION Memory bank scanIMPORTANT!: To perform memory bank scan, 2 or morebank channels MUST be programmed, otherwise the scanwill not start.qPush [S.MW](MR) several times to select memory bankmode.w Set the squelch level.eWhile pushing and holding [SCAN](2), rotate [DIAL] to se-lect the desired scanning type.• “ALL” for all bank scan; “BANK-LINK” for bank link scan or“BANK-x” for bank scan (x= A to Z; programmed bank groupsare only displayed.), “DUP” (appears only when duplex opera-tion is set) for duplex scan.r Release [SCAN](2) to start the selected scan.• Scan pauses when a signal is received.• Rotate [DIAL] to change the scanning direction, or resumesmanually.t To stop the scan, push [VFO].The bank-link setting can be changed in scan set mode.See page 97 for details.Duplex scan function: Repeatedly scans two frequencies(transmission/reception) during duplex scan operation.FMAμ 888148 800• During all bank/bank link scan • During bank scanFMAμ A88148 800FMFMA 145 000μ A01A01SCAN:ALLFMA 148 800μ A01A01SCAN:BANK-LINKFMA 148 800μ A01A01SCAN:BANK-AP SKIPSKIPP SKIPSKIPP SKIPSKIP• All bank scan selection• Bank scan selection• Bank link scan selectionSelectable between “A” to “Z”if programmed.[DIAL]
