Kenwood TKR-750 Programming Reference Manual

Also see for TKR-750: Brochure & specs Service manual Service manual Function reference Service manual

Version: 1.01 Field Programming Reference (FPRG) 266 EDIT MENU6.3.7 TX Required in IntervalIt can be enable to send a CW ID with the configuredinterval. (Refer to 6.3.2 TX Interval Time.)Note: “TX Required in Interval” function is not applicable whensending the CW ID with the “CW ID On” function.6.3.8 CW ID OverrideIt can send a CW ID with audio signal when the TXInterval Time expires during transmission. (Refer to 6.3.2TX Interval Time.)Note:! When sending the CW ID configured as CW ID Override On, theQT/DQT code configured to the channel is encoded regardlessof the Encode with QT/DQT configuration. (Refer to 6.3.11Encode with QT/DQT (CW ID).)! The CW ID is not sent even when the CW ID On function isenabled during transmission while CW ID Override is disabled.6.3.9 Send CW ID to RAA CW ID tone is sent to the front speaker and the RAterminal located on the rear panel. It can use to monitorand confirm by dispatcher.Note: The CW ID is only sent from the RA line when the channel isin Simplex mode. In this case, the CW ID is not sent fromthe speaker.6.3.10 CW ID on Channel ChangeIt can transmit a CW ID when the channel is selected orchanged. The TKR-750/850/751/851 transmits a CW IDregardless of the configuration of the CW Mod. DelayTime and the TX Interval Time.6.3.11 Encode with QT/DQT (CW ID)It can encode a QT/DQT (Primary) code configured toeach channel while sending a CW ID.Note: The TKR-750/850/751/851 sends the QT/DQT codeconfigured to each channel when Encode with QT/DQT isenabled, and it does not send the QT/DQT code whenEncode with QT/DQT is disabled. However, the new CW ID/CW Message is sent in conjunction with the Encode withQT/DQT configuration when the TKR-750/850/751/851sends another CW ID or CW Message while the CW ID isindependently sent. (Refer to 6.12 CW Message Window.)RangeCheckedThe CW ID is sent after theconfigured interval timer expires onlywhen TKR-750/850/751/851transmitted.Unchecked The CW ID is sent with the intervalconfigured in the “TX Interval Time”.Default UncheckedRangeCheckedThe CW ID is sent with an audiosignal when the TX Interval Timeexpires during transmission.UncheckedThe CW ID is sent after thetransmission ends when the TXInterval Time expires duringtransmission.Default UncheckedRange Checked “Send CW ID to RA” is enableUnchecked “Send CW ID to RA” is disableDefault UncheckedRangeChecked CW ID is sent when the channel isselected or changed.Unchecked CW ID is not sent even when thechannel is selected or changed.Default UncheckedRangeChecked CW ID is transmitted with QT/DQT(Primary) code of each channel.UncheckedCW ID is transmitted without QT/DQT (Primary) code of eachchannel.Default Unchecked