Kenwood TKR-750 Programming Reference Manual

Also see for TKR-750: Brochure & specs Service manual Service manual Function reference Service manual

6 EDIT MENU43 Field Programming Reference (FPRG) Version: 1.01It can configure the Decode code with a maximum of 16-digit DTMF Tone. Enter the code in the edit boxes fromNo. 1 to No. 40.Note: If the same DTMF code is configured in the different table, itmay use the same DTMF code to decode for the Air Remotefunction. In this case, the function may not work properly.(Refer to 6.9 Remote Control Window.)6.9 Remote Control WindowIt can configure the TKR-750/850/751/851 to becontrolled by other transceivers on the “Remote Control”window. It is possible to control functions assigned to thePF key or the Auxiliary Port by the Air Remote code.Air Remote activates the function configured previously(Channel Up function and Scan On/Off function, etc.)when the received code is same as the transmitted codefrom other transceivers. The code used in this function isreferred to as the “Air Remote code”.This window consists of PF key and AUX Input/Outputtabs and you can switch the window by clicking the tabs." Conditions od the Air Remote# When the Air Remote functions for the AuxiliaryInput (Level) and the PF key are assigned to thesame, the status of the Auxiliary Input (Level) portgets the preference over the operation of the PFkey. In this case, the Transpond code is not sentand the Air Remote function is canceled. Forexample, when the scan function is assigned to theAuxiliary Input (Level) port and activating, the PFkeys relating to the Scan operation and the AirRemote function are not acceptable.# It can select a timing to send a Transpond codefrom “Before”, “After” or “Both” the received AirRemote code is processed.Before:TKR-750/850/751/851sends the Transpond codeas soon as it receives the Air Remote code. TheTranspond code is not sent when the transmissionis restricted.After:TKR-750/850/751/851 sends the Transpond codeafter processing the function related received AirRemote code. The Transpond code is not sentwhen the transmission is restricted. Also it is notsent when that function cannot be processed. Thisoperation is the same as when the function isdisabled corresponding to the status of TKR-750/850/751/851 even when the PF key is pressed.Both:TKR-750/850/751/851 sends the Transpond codewhen receiving the Air Remote code and afterprocessing the received code. The Transpondcode is not sent when the transmission isrestricted.# TKR-750/850/751/851 uses the following channelto send the code during Scan. (Refer to 6.6.5Revert Channel.)Range 16 digits0 - 9, A - D, *, #Default No. 1 is 159D.No. 2 - No. 40 are blank.