Kenwood TKR-750 Programming Reference Manual

Also see for TKR-750: Brochure & specs Service manual Service manual Function reference Service manual

Version: 1.01 Field Programming Reference (FPRG) 426 EDIT MENU6.8 “Encode/Decode Table”WindowIt can configure the DTMF Encode/Decode code and thefunction relating to the Transpond function. You canconfigure this function when the DTMF signalling is used.This window consists of “Encode” and “Decode” tabs andyou can switch the window by clicking the tabs.Figure 6-15 Encode tabFigure 6-16 Decode tab6.8.1 Encode CodeIt can configure the Encode code with a maximum of 16digits of the DTMF Tone. Enter the code in the edit boxesfrom No. 1 to No. 32.6.8.2 FrequencyThis is a frequency to transmit Single tone as theTranspond code when the function assigned to the PFkey or the auxiliary port activates/deactivates. You canconfigure the frequency for both of “Activation” and“Deactivation”. Configure the frequency by the spinbuttons or directly enter the value to configure thefrequency.6.8.3 PeriodThis is a period to transmit Single Tone as the Transpondcode when the function assigned to a PF key or anAuxiliary port activates/deactivates. You can configure thetransmission period for both of “Activation” and“Deactivation”. Configure the period by the spin buttonsor directly enter the value to configure the period.6.8.4 SidetoneIt allows to transmit a sidetone when sending the DTMFcode. This function is used to feedback the audio tone tothe transceiver's speaker.Note: You cannot transmit the sidetone when the “OperationMode” is configured as “Simplex”. (Refer to 6.2.8 OperationMode.)6.8.5 Decode CodeRange 16 digits0 - 9, A - D, *, #Default No. 1 is 159D.No. 2 - No. 32 are blank.Range 100 - 3000 HzIn steps of 10 HzDefault 800 Hz (Activation)600 Hz (Deactivation)Range 100 - 3000 msIn steps of 50 msDefault 1000 ms (Activation)2000 ms (Deactivation)RangeChecked Transmits the sidetone with DTMFcode.Unchecked Not transmit the sidetone with theDTMF code.Default Checked