Kenwood TKR-750 Programming Reference Manual

Also see for TKR-750: Brochure & specs Service manual Service manual Function reference Service manual

Version: 1.01 Field Programming Reference (FPRG) 486 EDIT MENU6.9.3 Remote Access with QT/DQTIt can receive the Air Remote code depending on thematched/unmatched status of the received QT/DQTcode.Note:! This function is only available to receive the Air Remote code.This function does not affect the repeat operation.! If the check box is checked, the QT/DQT Decode function isperformed to receive the Air Remote code even when the QT/DQT Decode function is disabled as following.• The Off-hook Decode function is disabled and themicrophone is in the Off-hook position.• The monitor is enable:6.9.4 Clear To Transpond (RemoteControl)This is a timing to transmit a Transpond code. If checkbox is checked, TKR-750/850/751/851 waits to transmit aTranspond code until the channel is available.6.10 Function Port WindowIt can configure the functions that you can assign to theAuxiliary port on this window. This window consists of“AUX Select” and “AUX” tabs and it can switch thewindow by clicking the tabs.6.10.1 AUX Select TabIt can select operation type of AUX Input/Output ports onthis window.Figure 6-19 AUX Select tab" Function (AUX Select)It can assign this function to the AUX Input/Outputports 1 - 6 only. Select a operation type from “AUXInput”, “AUX Output”, “Channel Select”, and “Multi-table Select”.Note:! It can assign “Channel Select” and the “Multi-table Select” tothe AUX Input/Output ports 1 - 4 only.! It cannot change the order of the AUX Input/Output ports (1 -4) when assigning the “Channel Select” function to theseports. If the AUX Input/Output 1" port is assigned the “Multi-table Select”, the “Multi-table Select” function isautomatically assigned to AUX Input/Output ports (2 - 4).RangeCheckedTKR-750/850/751/851 receives theAir Remote code only when the QT/DQT code matches. Although the itperforms the repeat operation, it doesnot transmit when “TX Disable” isenabled.UncheckedTKR-750/850/751/851 receives theAir Remote code even when the QT/DQT code does not match or carrier. Itcannot enable the repeat operationwhen the repeat conditions do notmatch.Default UncheckedRangeCheckedWaits until the channel becomesavailable without sending theTranspond code when the channel isbusy.Unchecked Sends the Transpond code even if thechannel is busy.Default UncheckedRangeAUX Input This port works as the PF Input port.AUX Output This port works as the PF Output port.ChannelSelectMove to one of the CH 1 - CH 16channels when the voltage level of theAuxiliary Input/Output pots is High orLow.Multi-tableSelectSpecify one of the No. 2 to No. 16codes configured on the Multi-tablewhen the voltage level of the AuxiliaryInput/Output ports is High or Low.Default AUX Input/Output 1 - 5: AUX InputAUX Input/Output 6: AUX Output