2–6 1765 Network Printer Configuration GuideInstall the LAN CardFollow these steps to install the LAN card, as shown onthe facing page.Caution! Take the following steps to protect themain controller board while installing the LAN card.• Hold the board by its edges to avoid touching theconnectors or components.• Do not use magnetic tools when handling the board.• Wear charge-dissipative straps and work on antistaticsurfaces while handling the main controller board.• Avoid carpets in cool, dry areas where static may buildup.1. Place the main controller board flat on a table sothat the LAN card socket and bracket are on top (A).2. Rotate the LAN card bracket 90 degrees (B).3. Slide the LAN card onto the main controller board,so that the LAN card plugs into the main controllerboard and the LAN card panel fits through the maincontroller board (C).4. Insert the LAN card screws into the main controllerboard panel above and below the LAN card panel.Tighten the screws finger-tight. Rotate the LAN cardbracket 90 degrees so that it supports the LAN card(D).5. Slide the main controller board back into the printer.Make sure the board is positioned between the railsinside the printer (E).6. Tighten the two screws finger-tight to fasten themain controller board to the rear of the printer (F).
