2–8 1765 Network Printer Configuration GuideConnecting and Verifying theSilentwriter 1765This section describes the steps to connect the networkcable to your 1765 and verify its operation. The steps are1. Identify the LAN card panel.2. Connect the network cable.3. Turn on the printer.4. Print a configuration page.After completing the tasks in this section you will beready to install NEC 1765 software and connect theSilentwriter to your network.Identify the LAN Card PanelThe diagram shows the LAN card panel and itscomponentsConfiguration Button: Use this button to print aconfiguration page or restore the LAN card to itsfactory default settings.Green LED: Lights up when the Silentwriter isreceiving a packet or downloading flash-ROMinformationRed LED: Lights up when transmitting a packetPrinting a Configuration PageTo print a configuration page, turn on the printer andpress the configuration button. For more informationabout the configuration page, see “Print a ConfigurationPage” on page 2-13.Restoring Factory LAN Card SettingsYou can use the configuration button to restore the LANcard to factory default settings.Caution! Any custom settings will be lost whenyou restore factory default settings. Before restoring,print a configuration page so you have a record ofcustom settings.To use this button as a reset button1. Turn the power off.2. Press and hold the button.3. Turn the printer power on.4. Continue to press the button for at least 15 seconds.5. Release the button.Red LEDGreen LEDLocalTalk (AppleTalk) connectorLAN Card PanelTwisted PairEthernetConnectorThin CoaxialEthernetConnectorConfigurationButton
