Replacing a Plug-in► To replace a Plug-in, simply select its slot and load a new Plug-in as described above.You can also recall the search query that was used to find the Plug-in preset currently loaded in thePlug-in slot (see section ↑4.8, Using Quick Browse for more information).7.1.4 Adjusting the Plug-in ParametersThe procedure for adjusting the Plug-in parameters is common to all types of Plug-ins and allsets of Channel properties. It is described in section ↑3.3.6, Navigating Channel Properties,Plug-ins, and Parameter Pages in the Control Area.Native Instruments and External Plug-ins only: You can also adjust the Plug-in parameters via theown user interface of the VST/AU plug-in. More on this in ↑7.3, Using Native Instruments and Ex-ternal Plug-ins.7.1.5 Bypassing Plug-in SlotsYou can bypass (or “mute”) any Plug-in slot. When a Plug-in slot is bypassed, the Plug-in itcontains is temporarily removed from the signal flow and does not process the audio passingthrough the slot. Instead, the incoming audio is directly sent to the next Plug-in slot for furtherprocessing (or to the channel’s output if you bypass its last Plug-in slot).Bypassing Plug-in slots can be very useful in various situations, for example:▪ Bypassing and re-enabling an effect during a live performance.▪ Comparing the sound with and without an effect.▪ Troubleshooting complex effect chains and routings (“Where does this strange reverb tailcome from?”).To bypass a Plug-in, do the following:1. If you want to bypass a Plug-in of the Master, click the MASTER tab in the top left cornerof the Control area.2. If you want to bypass a Plug-in of a Group, click the desired Group on the left of the Ar-ranger, and click the GROUP tab in the top left corner of the Control area.Working with Plug-insPlug-in OverviewMASCHINE MIKRO - Manual - 312
