Doubling Your PatternYou can quickly double the content of the Pattern:► Press F2 (DOUBLE) to double the content of the Pattern.→ The length of the Pattern is doubled. All events in the original Pattern are duplicated tothe second half of the extended Pattern. Any events that were located beyond the originalPattern’s end are moved beyond the extended Pattern’s end.You can otherwise double your Pattern via Pattern mode — see section ↑11.4.9, Doubling a Patternfor more information.Preparing the Next EventsYou can adjust the velocity of the next events that you will create by pressing the pads. Thevelocity of the events you create depends on the state of the Fixed Velocity option:► Press F3 (FIX VEL) to enable/disable the Fixed Velocity option.▪ If Fixed Velocity is enabled, all events you create will have the velocity set by turning theControl encoder. The Fixed Velocity value is momentarily shown on the display as you turnthe Controller encoder.▪ If Fixed Velocity is disabled, the velocity of each event will depend on how hard you hit thepad when creating the event.These parameters affect only your next hits on the pads: They don’t modify the velocity of existingevents.11.3.2 Editing Events in Step ModeIn Step mode you can quickly adjust the parameters of events on particular steps.Editing Events in Step Mode on the ControllerIn Step mode on your controller, each event you create is automatically selected (and the pre-vious selection is dropped). You can then adjust the pitch and position of this last createdevent via the various commands available on your pads while holding SHIFT — see sectionWorking with PatternsRecording Patterns with the Step SequencerMASCHINE MIKRO - Manual - 477
