Element DescriptionSCALE SectionVelocity Adjusts the velocity response of the drum. Available values rangefrom -100.0% to 100.0% (default value). At zero (mid course), thedrum is played at full velocity, no matter how hard you hit the keys(or pads). From that mid position, by turning the knob to the rightyou increase the positive velocity response and make the drum moresensitive to the velocity at which you hit the keys/pads. From themid position, turning the knob to the left as the inverse effect: theharder you hit the key/pad, the softer the resulting drum sound willbe.9.7.2 Cymbal – RideThe Ride engine is an acoustic emulation that allows the cymbal to be hit in many differentways through the use of the Edge and Bell parameters. The sonic palette ranges from soft Jazz-like rides to more noisy cymbals.The parameters described below are presented as they appear in the Control area (Arrange view).The same parameters are available in the Plug-in panel within the Plug-in Strip (Mix view) — formore information please refer to section ↑13.4, The Plug-in Strip.Main PageElement DescriptionMAIN SectionEngine Selects the engine used in the Cymbal plug-in. Available enginesinclude Crash and Ride.Tune Adjusts the pitch of the drum played by the middle C, measured inMIDI note numbers and cents. Available values range from 0.00 to1.00. The default value is 0.30.Decay Adjusts the duration of the sound’s tail, measured as a percentage.Available values range from 0.0 to 100.0% (default: 70.0%).Using the DrumsynthsThe CymbalsMASCHINE MIKRO - Manual - 438
