Nokia 6090 AT Command Set 42AT+CPWD="P2","5678","12345678"changes “PIN2 code” from the old 5678 value, to 12345678.+CR Service Reporting ControlThis command controls the presentation of the +CR intermediate result code. Ifenabled, the result code is transmitted at the point during the connect negotiationduring which the speed and quality of service to be used have been determined,before any error control or data compression reports are transmitted, and before anyfinal result code (e.g., CONNECT) is transmitted. (GSM 07.07)Syntax:AT+CR= Set service reporting control mode.Default option is 0.AT+CR? Query current setting.Response is +CR:.AT+CR=? Show supported values.Response is +CR:(list of supported's).Parameters for :0 Disable reporting.1 Enable reporting.+CRC Cellular Result CodesThis command controls whether or not the extended format incoming call indication isused. When enabled, an incoming call is indicated to the DTE with the result code+CRING: instead of the normal RING. See also section Result Codes frompage 77 onwards. (GSM 07.07)Syntax:AT+CRC=[] Set incoming call indication mode.Default option is 0.AT+CRC? Query current settingResponse is +CRC:AT+CRC=? Show supported modes.Response is +CRC:(list of supported's).Values for :0 Disable extended format call indication.1 Enable extended format call indication.
