Nokia 6090 AT Command Set 80Copyright © 2001. Nokia Mobile Phones. All rights reserved.are active2 call has been forwarded3 call is waiting4 this is a CUG call (also present)5 outgoing calls are barred6 incoming calls are barred7 CLIR suppression rejected8 call has been deflected: refer "Closed user group +CCUG"See details about +CSSN Supplementary Service Notifications page 49.+CSSU Unsolicited Supplementary Service Notification+CSSU: [,[,, [,,]]]is given when +CSSN=,1 and some supplementary service notification is given bynetwork during MT call setup or during a voice call; note that also remote release of aheld call is informed with this result code.In MT call setup case, this result code is sent to TE after every (possible) +CLIPresult code. In case of a waiting call, this is given after +CCWA result code (butdiscarded if TA is in on-line data. (GSM 07.07).:0 this is a forwarded call (MT call setup)1 this is a CUG call (also present)(MT call setup)2 call has been put on hold (during a voicecall)3 call has been retrieved (during a voicecall)4 multiparty call entered (during a voice call)5 call on hold has been released (this is nota SS notification) (during a voice call)6 forward check SS message received (canbe received whenever)7 call is being connected (alerting) with theremote party in alerting state in explicitcall transfer operation (during a voice call)8 call has been connected with the otherremote party in explicit call transferoperation (also number and subaddressparameters may be present) (during avoice call or MT call setup)9 this is a deflected call (MT call setup): refer "Closed user group +CCUG": string type phone number of format specified by : type of address octet in integer format (GSM 04.08): string type subaddress of format specified by : type of subaddress octet in integer format (GSM 04.08)See details about +CCWA page 17.+CUSD Network Initiated Unstructured Supplementary Service Data+CUSD: ,,is given when +CUSD=1 and network initiated 'notify' or 'request' USSD messagereceived; discarded if in on-line data state (also when V.80 in-band mode is enabled).
