Nortel CallPilot Server User Manual

Also see for 1000 Con?guration guide: Brochure Reference User manual Overview User guide

Contents

108 Chapter 6 Testing the CallPilot installationThe system-ready indicators described in this section appear when yourestart the server, and also when CallPilot is running if a change in systemreadiness status occurs.The system-ready indicators appear only if the Configuration Wizard haspreviously been run on the server. The CallPilot server is not ready toaccept calls if the Configuration Wizard has not been run.Note: It is possible that the Configuration Wizard was run at the factoryor channel partner’s site before it was shipped to the customer site.If this is the case, then system-ready indicators are visible when theCallPilot server is started the for first time at the customer site.Checking system readiness by observing the dialog box messagesA system-ready indicator dialog box appears on the screen any time there isa change in system readiness status. You can close these dialog boxes atany time. If the status changes, a dialog box appears again.At all times, a system-ready indicator icon appears in the task bar in thebottom right corner of the screen. To view the system-ready indicator dialogbox after you close it, double-click the system-ready indicator icon. To viewthe current status (boot, pass, warn, or fail), place the mouse pointer overthe system-ready indicator icon. Help text (roll-over text), which states thecurrent status, appears after a few seconds.Immediately after you log on to the server, the dialog box, shown in "SRICallPilot boot fail" (page 108), appears on the screen if CallPilot servicesare not yet fully operational. It can take approximately 1 minute after logonfor the dialog box to appear.SRI CallPilot boot failThe Elapsed Time indicates how much time has passed since the CallPilotapplication began its boot sequence.Note: This dialog box may not appear if enough time has passedbetween starting up the CallPilot server and logging on for CallPilotservices to become fully operational. It takes approximately 10 minutesafter starting up the CallPilot server for CallPilot services to becomefully operational.Nortel CallPilotCommunication Server 1000 and CallPilot Server ConfigurationNN44200-312 01.02 Standard5.0 3 May 2007Copyright © 2007, Nortel Networks.