110 Chapter 6 Testing the CallPilot installationAlternative methods for verifying that CallPilot is ready to accept callsView events in CallPilot Manager or in the operating systemEvent Viewer on the serverThe Pass, Warning, and Error system-ready indicator messages appear asevents in the Event Browser and Alarm Monitor in CallPilot Manager, and inthe operating system Event Viewer on the server.By default• the Event Browser and Alarm Monitor show only the latest 100 eventsChange the default settings to remove the system-ready indicator eventsfrom the Event Browser and Alarm Monitor windows.• the Event Browser lists only Critical eventsYou can change the Filter Criteria so that Major, Minor, and Informationevents are listed as well.For detailed instructions on viewing events, see the CallPilot Manageronline Help.Observe the HEX display (for the 201i server only)The HEX display on the 201i server faceplate displays the followingmessages.Note: The DOWN, OK, MIN, MAJ, CRI, and "???" messages canappear regardless of whether the Configuration Wizard has been run.Some MIN, MAJ, and CRI events may appear because the server hasnot been configured. These events may be resolved after running theConfiguration Wizard. The BOOT, PASS, WARN, and FAIL messagesare system-ready indicator messages; they do not appear if theConfiguration Wizard has not been run.IPE CallPilot serverHEX display DescriptionDOWN The operating system is starting.OK The operating system start sequence has passed.BOOT CallPilot is starting and is not yet fully operational.Please wait.PASS CallPilot is fully operational and ready to accept calls.WARN CallPilot is ready to accept calls; however, someservices failed the start sequence. Check the eventlog for further information.FAIL CallPilot failed the start sequence and cannot acceptcalls. Check the event log for further information.Nortel CallPilotCommunication Server 1000 and CallPilot Server ConfigurationNN44200-312 01.02 Standard5.0 3 May 2007Copyright © 2007, Nortel Networks.