112 Chapter 6 Testing the CallPilot installationIf the CallPilot server is not connected to a Nortel Server Subnet(NS Subnet), then type exit and press Enter to close the CommandPrompt window. Then continue with "Verifying that CallPilot canreceive calls" (page 112).—End—Testing the connection to the NNS SubnetIntroductionThis procedure tests the network connection between the server and theNortel Server Subnet (NS Subnet). This applies only if CallPilot has an NNSSubnet card and is connected to an NNS Subnet.ATTENTIONDisconnect the NNS Subnet from the ELAN subnet before testing to ensure thatthe ping is testing only the NNS Subnet.To test the connection to the NNS SubnetStep Action1 Click Start -> Programs -> Accessories -> Command Prompt.Result: The Command Prompt window appears.2 Type ping followed by the NNS Subnet IP address of another PC onthe NNS Subnet, and then press Enter.Example: ping 255.255.255.255Result: The display indicates a successful ping.3 Type exit, and then press Enter to close the Command Promptwindow.—End—Verifying that CallPilot can receive callsIntroductionThe following procedure is a basic test to verify that CallPilot is able toreceive calls from the CS 1000 system and answer those calls. A morethorough test that requires the use of CallPilot Manager is described in"Testing the CallPilot software and channels" (page 113).Nortel CallPilotCommunication Server 1000 and CallPilot Server ConfigurationNN44200-312 01.02 Standard5.0 3 May 2007Copyright © 2007, Nortel Networks.