Configuring the route data block for Network Message Service 81Prompt Response Description Press Enter until you reach the end of theoverlay (the REQ prompt).REQ If you are finished adding phonesets,enter **** to exit. To add anotherphoneset, return to the top of the table.—End—Configuring the route data block for Network Message ServiceIntroductionIf you have purchased Network Message Service (NMS) to allow a numberof switches to share CallPilot (installed on only one switch), then configurethe route data block. This section provides instructions for this step.For details on additional switch configuration for NMS, see the"Configuring the switches" chapter in the CallPilot Network Planning Guide(NN44200-201).Note: Ensure that Digit Manipulation (DMI in overlay 86) is not usedto insert ESN access codes at the sending switch. ESN access codeinsertion must be done at the receiving switch (INAC in overlay 16).To modify the route data blockStep Action1 Load overlay 16.2 For each prompt listed below, type the response indicated. Forthose prompts that are not listed, you can accept the default bypressing Enter.Prompt Response DescriptionREQ NEW orCHGTYPE RDB Route data blockCUST xx Customer number (0-99)ROUTE Route numberPNI Customer Private Network ID of thenon-local target CS 1000 systemNCRD Yes Network call redirection provides theCLID display information.Nortel CallPilotCommunication Server 1000 and CallPilot Server ConfigurationNN44200-312 01.02 Standard5.0 3 May 2007Copyright © 2007, Nortel Networks.
