118 Chapter 6 Testing the CallPilot installationATTENTIONIf you do not hear the exact message, You have one new message..., thisindicates that the wrong prompts have been installed or that CallPilot didnot install properly.If you did not hear the correct message, contact your Nortel customersupport representative.4 Press 2 to play the message, and then listen to it.5 Press 76 to delete the message.Result: CallPilot plays the following prompt: Message 1deleted.ATTENTIONIf you do not hear the exact message, Message 1 deleted, thisindicates that the wrong prompts have been installed or that CallPilot didnot install properly.If you do not hear the correct message, contact your Nortel customersupport representative.6 Press 83 and then hang up the phone.—End—Verifying that each call channel and multimedia channel is functioningproperlyThese tests verify that the call channels and multimedia (DSP) channels arefunctioning properly.The call channel is the channel that carries the call signal from the CS 1000system to CallPilot. The multimedia channel is the CallPilot channel thatprocesses the call and provides voice, fax, or speech recognition capability.These tests consist of the following procedures:• "To test call channels and voice channels" (page 119)(Skip thisprocedure if you do not have voice channels installed.)• "To test call channels and fax channels" (page 121) (Skip this procedureif you do not have fax channels installed.)• "To test call channels and speech recognition channels" (page 122) (Skipthis procedure if you do not have speech recognition channels installed.)• "To restore the SDN Table and put all channels back in service" (page124)Nortel CallPilotCommunication Server 1000 and CallPilot Server ConfigurationNN44200-312 01.02 Standard5.0 3 May 2007Copyright © 2007, Nortel Networks.