116 Chapter 6 Testing the CallPilot installation—End—To leave a messageStep Action1 From any active phoneset that is connected to the CS 1000 system,dial the Voice Messaging Service DN that you have just created.Result: CallPilot plays the following prompt: CallPilot fromNortel Network. Mailbox?Note: If CallPilot does not answer the call or you do not heara prompt, then check that the call channels and multimediachannels are in Idle state, as described in "Verifying that eachcall channel and multimedia channel is functioning properly"(page 118).2 Type the mailbox number followed by number sign (#) (for example,8050#).Result: CallPilot plays the following prompt: Password?3 Type the mailbox password 135246#.Result: CallPilot plays the following prompt: The temporarypassword assigned by your administrator must bechanged. To access your mailbox, please press 84and change your password.4 Press 84.Result: CallPilot plays the following prompt: Password change.To authorize the change, please enter your oldpassword followed by number sign.5 Type 135246#.Result: CallPilot plays the following prompt: Please enter yournew password followed by number sign.6 Type a new mailbox password followed by number sign (#) (forexample, 805011#).Result: CallPilot plays the following prompt: Please enter yournew password again followed by number sign.7 Type the new mailbox password again to confirm (for example,805011#).Nortel CallPilotCommunication Server 1000 and CallPilot Server ConfigurationNN44200-312 01.02 Standard5.0 3 May 2007Copyright © 2007, Nortel Networks.