60 Chapter 4 Configuring the CS 1000 systemNotes:• The CS 1000 system has dual CPUs.• If the CS 1000 system is also connected to a Nortel Server Subnet (NSSubnet), you must define a gateway IP address.ATTENTIONTo change an IP address after CallPilot is installed and running, you must dothe following:1 Courtesy stop and shut down CallPilot.2 Change the IP addresses on the switch, as described in this section.3 Restart CallPilot.4 Rerun the CallPilot Configuration Wizard to update the switch IP addressinformation.To configure the IP addresses and enable the Ethernet interfaceThe following data is used in examples in this procedure:Data Value (examples only)Primary IP address 47.1.1.10Primary Host Name PRIMARY_HOSTSubnet mask 255.255.255.0Default gateway IP address 47.1.1.1Network IP address 0.0.0.0Step Action1 Load overlay 117.2 Perform the following substeps to check the current IP addresses tosee if they already match what you plan to configure for CallPilot.If the current values displayed by the following commands must beupdated, then continue with the remaining steps in this procedure.Otherwise, go to step 15.a. Type PRT HOST and press Enter.b. Type STAT HOST and press Enter.c. Type PRT MASK and press Enter.d. Type PRT ELNK and press Enter.3 Load overlay 137.4 Type DIS ELNK and press Enter.Nortel CallPilotCommunication Server 1000 and CallPilot Server ConfigurationNN44200-312 01.02 Standard5.0 3 May 2007Copyright © 2007, Nortel Networks.
