Utility mode 10VarioLink 2221/2821/3621 10-67Utility mode Chapter 1010.22 Specifying software switch settings (machine func-tions)By specifying the software switch settings (“Mode Selection”, “Bit Selection”and “Hex Selection”), various machine functions can be changed to meetyour specific needs.2 ReminderDo not change any modes or bits other than those described in this man-ual.2 NoteWhen “Enhance Security” is set to “ON”, the software switch settingscannot be changed.Software SW settingsExamples of settings for “Bit Selection” (binary numbers) and “HEX Selec-tion” (hexadecimal numbers) are shown below.Parameter DescriptionMode Selection The parameter to be specified is expressed as a three-digitnumber. Use the keypad to type in the value.Bit Selection The bits are the eight numbers that construct the mode sta-tus. By specifying a binary number (0 or 1) for each of the bits(0 through 7), a setting for each parameter can be specified.HEX Selection Specify a setting for each mode as a hexadecimal number (0through 9 and A through F). Bit setting “0011 0000” is ex-pressed as the hexadecimal setting “30”.Specify a mode setting by using either bits or hexadecimalvalues.Decimalnumber“Bit Selection” setting (binarynumber)“HEX Selection” setting (hexadeci-mal number)0 0000 0000 001 0000 0001 012 0000 0010 023 0000 0011 034 0000 0100 045 0000 0101 056 0000 0110 06
