Transmission 2VarioLink 2221/2821/3621 2-35Transmission Chapter 22.10 When unable to sendIf the fax could not be sent because the recipient’s line was busy, it will becalled again (auto redial).If a different fax is queued, the fax number is automatically redialed after thequeued fax is sent.If the fax could not be sent even after automatically redialing, a transmissionreport is printed. This report contains part of the first page of fax that couldnot be sent (except if the “Quick Scan TX” function was used).!DetailAs a factory default, this machine is set to automatically redial up to 5times at 1 minute intervals. The settings for the number of redials and theinterval can be changed. For details, refer to “Specifying the receptionmode and the number of rings (RX Functions)” on page 10-44.Software switch settings can be specified to select whether or not thefirst page of the image is added to the results report. For details on thesoftware switch settings, refer to “Specifying software switch settings(machine functions)” on page 10-67.If it is not necessary that the transmission report be printed, the settingcan be changed. For details, refer to “Specifying report output settings(Report Settings)” on page 10-48.To send the fax againIf a fax could not be sent, follow the procedure described below to try send-ing it again.1 Touch [Job List], then [Type], and then search for documents that couldnot be sent.If [Retry] or [Change Destination] appears, the fax can be resent withouthaving to scan the document again.2 Touch [Retry] to send the fax to the same recipient.– To send the fax to a different recipient, touch [Change Destination].– If neither button appears, scan the document and try faxing it again.
