Utility mode 10VarioLink 2221/2821/3621 10-91Utility mode Chapter 10Specifying whether transmission source information is added whenperforming an IP relay operation or forwarding received documents(mode 352)Specify how transmission source information is added when performing anIP relay operation or forwarding received documents.Settings at time of purchaseSpecifying the settingDuring the production of this unit, the settings in the shaded cells were se-lected. The numbers on the right side indicate the page numbers with de-scriptions for the corresponding function.5, 4, 3, 2, 1,0----------------------- 101000 *Do not change these bitswhen specifying settingsfor this function.---------Bit Description Setting Description Page Refer-enceBit 7 6 5 4 3 2 1 0Setting 1 1 0 1 0 0 0 0 (HEX: D0)Bit Description Setting Description Page Refer-ence7 ----------------------- 1 *Do not change this bitwhen specifying settingsfor this function.----------6 Specifies wheretransmission sourceinformation is addedwith IP relay opera-tions.0 Outside of the document ----------1 Inside the document5 Specifies whether ornot transmissionsource informationis added to receiveddocuments that areforwarded.0 Not added p. 10-531 Added4 Specifies wheretransmission sourceinformation is addedwhen a receiveddocument is for-warded.0 Outside of the document1 Inside the document3, 2, 1, 0 ----------------------- 0000 *Do not change these bitswhen specifying settingsfor this function.----------
