Oki COREFIDO B822dn User Manual

Changing settings from the operator panel- 122 -ItemFactorydefaultsettingDescriptionBottom Margin 6millimeter Sets the bottom margin of IBM 5577emulation. It ranges from 4 mm to 100 mm.Image Wrap Mode ON Specifies whether to print on Image WrapMode.Landscape Direction ReverseLandscapeSpecifies the Landscape Direction.CAN Function ON Specifies the operation of CAN command.Japanese Font Mincho Specifies Japanese font.Auto Scale On Automatically enlarge or reduce.Scale Adjustment 0% Sets the scale adjustment at auto scale.Value range: -10% ~ +10%Display condition: Auto scale is set to [ON].Scale 100% Sets the scale.Value range: 50% ~ 250%Display condition: Auto scale is set to [Off].Japanese Font Size 9.5 Specifies the English character size.Value range: 6.0 ~ 72.0 pointsDefault Edit Size Auto Specifies the edit size.X Dimension 210millimeter Sets the custom X Dimension.Value range: 105 ~ 297 mmDisplay condition: Default Edit Size is set to[Custom].Y Dimension 297millimeter Sets the custom paper length.Value range: 148 ~ 431 mmDisplay condition: Default Edit Size is set to[Custom].ESC/P Setup Kanji Font Auto Selects the Kanji font to be used.ANK Font Auto Selects the ANK font to be used.Symbol Set Kana Set the extended graphics/kana code of theANK Charset table.Zero Character Normal Sets whether to print ANK zeros withslashes.Reduction Print Normal Sets the reduction method of paper.Print Position 8.5millimeter Sets the print position.The actual print position may change withina range of ±2 mm.H Offset 0.0millimeter Corrects the entire print position in thehorizontal direction in increments of 0.5 mmaccording to the edit direction. When set inthe plus direction, the print position iscorrected to the right.V Offset 0.0millimeter Corrects the entire print position in thevertical direction in increments of 0.5 mmaccording to the edit direction. When set inthe plus direction, the print position iscorrected to the top.Right Margin Width Set the right margin. If some charactersexceed the right margin, Auto Fukkai Kinouwill be performed.CR Function CR Sets the actions when receiving a CR code.Auto LF CR+LF Sets the actions when some charactersexceed the right margin.