Oki LE850 Technical Reference

Also see for LE840: User guide

Contents

general description

- 11 -5. DEFAULT SETTINGIf Zebra command parameters, such as paper width, are not sent to the Oki Data printer, settings with keyoperations are required to ensure the Oki Data printer operates properly.In this case, enabling the Z-MODE on the printer allows parameter settings with key operations.The set parameters are retrieved when the program of the Z-MODE is started.An example of the operating procedure for LE840/LE850 is shown below.Operation ExamplePower OFF (1) Power off state[FEED] [PAUSE] (2) While holding down the [FEED] and[PAUSE] keys, turn on the printer power.SYSTEM MODE VX. X<1> DIAG.<2> PARAMETER SET<3> ADJUST SET<4> TEST PRINT(3) The system mode menu is displayed.[DOWN] x 11SYSTEM MODE VX. X<10> RFID<11> RTC<12> Z-MODE<13> USB MEMORY(4) Press the [DOWN] key until the cursor stopsat <12>Z-MODE.[ENTER] (5) Press the [ENTER] key.<12> Z-MODEOFFON SETTING OFFON SETTING ON(6) Z-MODE setting menuEnable or disable the Z-MODE with the[UP] or [DOWN] key.[DOWN] (7) Press the [DOWN] key.<12> Z-MODEOFFON SETTING OFFON SETTING ON(8) Z-MODE is enabled but the BASIC systemmode program is not activated.[DOWN] (9) Press the [DOWN] key.<12> Z-MODEOFFON SETTING OFFON SETTING ON(10) Z-MODE is enabled and the BASICsystem mode program is activated.[ENTER] (11) Press the [ENTER] key.SET PARAMETER (12) Z-MODE’s parameter setting menu isdisplayed.[PAUSE] (13) Press the [PAUSE] key.LABEL LENGTH0105.0 mm(14) Label length settingSet a value using the [FEED] or[RESTART] key. To move the cursor,use the [PAUSE] key.