Oki LE850 Technical Reference

Also see for LE840: User guide

Contents

general description

- 53 -8.20 ^BU UPC-A BAR CODEFormat: ^BUo,h,f,g,eo = Font rotationN : 0°R : 90°I : 180°B : 270°When omitted: Value of ^FW* The point of origin differs depending on the coordinate designated in ^FT and ^FO.h = Bar code height (in dots)203-dpi printer: LE8401 to 800 dots300-dpi printer: LE8501 to 1200 dotsWhen omitted: Value of ^BY*1 If the value after dot-to-mm conversion exceeds 100 mm, it is corrected to 100 mm.*2 If 0, a string, or other value is selected, it is corrected to 10 dots.f = Print interpretation lineY : PrintedN : Not printedWhen omitted: Yg = Print interpretation line above codeY : PrintedN : Not printedWhen omitted: Ne = Print check digit in interpretation line and interpretation line above codeY : PrintedN : Not printedWhen omitted: Y*1 The character type of the interpretation line is switched depending on the set value for the modulewidth of ^BY.In the case of 203-dpi printerModule width is 2 or less: Font AModule width is 3 or more: Font EIn the case of 300-dpi printerModule width is 4 or less: Font AModule width is 5 or more: Font E*2 Data other than numeric values, if any, are converted to ‘0.’*3 When the interpretation line above code is to be printed with Oki Data, the header and terminator(system number and check digit) are printed outside the guide bars.In the case of Zebra, the interpretation line above code is printed at the center between the guidebars.*4 To print the interpretation line above code, the interpretation line parameter (parameter f) needs tobe set to “Y.”*5 If the command is sent without setting data (only ^FS and ^XZ are set while ^FD^FS and ^FD arenot set), the barcode will not be printed.