Oki LE850 Technical Reference

Also see for LE840: User guide

Contents

general description

- 136 -8.97 ^MU SET UNITS OF MEASUREMENTFormat: ^MUa,b,ca = dot/inch/mmD : DotI : InchM : mmDefault: “dot/mm/inch” in the default setting fileWhen omitted: This command is ignored.b = Format base in dpi150, 200, 300When omitted: This command is ignored.c = Conversion dpi300, 600When omitted: This command is ignored.*1 While the individual position and size vary depending on whether the ^MU/^JM command is placedbefore or after ^FO/^FT/^LH/^LS/^LL/^PW or other command with Zebra, the position and the sizevary per label with Oki Data.*2 Drawing running over in the horizontal direction is printed as it is with Oki Data. However, whenmagnified, the portion running over the set width is not printed. In the case of Zebra, drawingrunning over the set width is not printed. (If the drawing data before magnification is set to a valueexceeding the set width after magnification, the drawing data before magnification is printed withoutbeing magnified horizontally.*3 As with the case where the format base dpi is 200 and the conversion dpi is 300, if the conversionresult is 1.5 times the base, the result is ignored.*4 The conversion dpi shall always exceed the format base dpi.*5 In the case of Zebra, magnified printing is not performed for ^BD (UPS Maxicode) and ^BR (GS1DataBar), it is performed with Oki Data.*6 While the paper length is extended with magnification, if it exceeds 0355.6 mm (14 inches), themagnification is disabled and same-size printing is performed.