Oki LE850 Technical Reference

Also see for LE840: User guide

Contents

general description

- 50 -8.18 ^BR GS1 DATABAR BAR CODEFormat: ^BRa,b,c,d,e,fo = Font rotationN : 0°R : 90°I : 180°B : 270°When omitted: Value of ^FW* The point of origin differs depending on the coordinate designated in ^FT and ^FO.b = GS1 DataBar-14 family1 to 121 : GS1 DataBar 142 : GS1 DataBar 14 Truncated3 : GS1 DataBar 14 Stacked4 : GS1 DataBar 14 Stacked Omnidirectional5 : GS1 DataBar Limited6 : GS1 DataBar Expanded7 : UPC-A8 : UPC-E9 : EAN-1310 : EAN-811 : UCC/EAN-128 and CC-A/B12 : UCC/EAN-128 and CC-CWhen omitted: 1*1 When the GS1 DataBar family notified by this command is "6: GS1 DataBar Expanded" and thenumber of segments is an even number other than 22, the GS1 DataBar family notified to TPCLshall be "6: GS1 DataBar Expanded Stacked."c = Magnification factor1 to 10When omitted: 2d = Separator height (unsupported)1, 2* Operation is performed with the fixed value 1.e = Bar code height (in dots)1 to 32000 dotsWhen omitted: 25 dots* This parameter is valid only when the GS1 DataBar family is set to "11: UCC/EAN-128 and CC-A/B” or "12: UCC/EAN-128 and CC-C" and set to the value obtained after "c = Magnificationfactor" is applied. If the calculation result exceeds 100.0 mm, it is corrected to 100.0 mm.f = Segment width2 to 22When omitted: 22*1 When the bar code is rotated at /90°/180°/270° on the coordinate specified in FO command, thebar code is not printed at the specified position.*2 When the bar code is rotated at 0°/90°/180°/270° on the coordinate specified in FT command, thebar code is not printed at the specified position.