- 62 -3. Scan• Simple Scan mode: You can start scanning anytime if the machine is instandby status.• Manual Scan mode: Turn on the Remote Scan function on the display screenbefore starting scanning.• Secure Scan mode: You can just operate from a computer specified whenyou turn on the remote scan function on the display screen. Only onecomputer can be connected at a time.If you perform a remote scan via the WSD Scan connection, you can scan from computersthat are already registered in this machine, regardless of the Remote Scan modes.1 Press the (SETTING) button on the operator panel.2 Press the button to select [Admin Setup] and press the button.3 Enter the administrator password, and then press the (OK) button.The factory default administrator password is "999999". If the administrator password is changed, enter theupdated password.4 Press the or button to select [Scanner Setup] and press the button.5 Press the or button repeatedly to select [PC Scan Mode] and press thebutton.6 Press the or button to select the mode and press the button.7 Press the button until the home screen is displayed.If [Manual Scan Mode] or [Secure Scan Mode] is selected, remote scan menus appearon the home screen.If you use ActKey, you can start scanning according to the settings you specified just byclicking the button.ActKey and scanner driver are included in the software DVD-ROM, and will be automaticallyinstalled if [Install Optional Software] is selected when installing the software.Starting Scanning on a Device (ActKey)1 Press the (SCAN) button on the operator panel.2 Set a document in the ADF or on the document glass.3 Press the button to select [Computer] and press the button.4 Check that [Select A Connecting PC] is displayed, and then press thebutton.5 According to the connection method of the machine and computer, press theor button to select [From Network] or [From USB Interface], and thenpress the (OK) button.6 For the network connection, destination computer to which scan data will besent is displayed on the operator panel. Press the or button to selectthe destination, and then press the (OK) button.If the target computer is not listed in the destination computers, register the computer with Network Configuration.Registering the Machine (New Device) to a Computer Using Network Configuration7 Press the button to select [Select An Application] and press the (OK)button.• If you select [Application], the application that you specify [Application-1] of ActKey or dedicated application forWindows starts, and then the scanned image is displayed on the application.• If you select [Folder], the scanned document is saved in the specified folder.• If you select [PC-FAX], a fax transmission application starts. After sending the scanned document, send a faxwith the fax transmission application on your computer.Using ActKey
